The water heater

CHARACTERISTICS

Enamelled tanks and heating bodies in compliance with hygiene standards

Accuracy and reliability over time of the electronic thermostat

Heating indicator
Anti-dry heating: no heating up if the appliance is not filled with water

7 capacities from 50 to 300 litres and 3 diameters (505, 570 and 575 mm) adapted to each need

Delivered with a 3/4″ rotating dielectric connection

Agro kit as an accessory: high temperature probe and ACI transformer for a 100 to 300 litre water heater (except HM) for agricultural or industrial use.

5-year warranty on the water heater and parts.

CHARACTERISTICS

Stainless steel water heater 80°C Tri 400V / 1x230V
Heating thermostat 65-95°C
Double outlet :

• 1 mixed outlet (milk mixer supplied)
• 1 outlet 80°C

Brass safety group supplied
Stainless steel mixing tube
2 year warranty on the tank
1 year warranty on electronics

The connection of the network to the hot water outlet must be made using a dielectric fitting or a cast iron sleeve (brass fittings are forbidden at this level).

It is mandatory to install a safety group on the cold water inlet (NFC15-100 ch559-3).

It is compulsory to install a thermostatic mixing valve at the head of the hot water distribution network or at the tapping points (decree of 15/12/06).

Requires annual maintenance of the tank and anode.

If the network pressure exceeds 5 bar, a pressure reducer must be installed at the start of the general distribution.

If composite pipes are used (PER, PVC, etc.), it is essential to install a temperature limiter at the outlet of the water heater, set according to the performance of the material used.

Never install a valve or non-return valve between the valve and the safety group and the tank.

Source : Guide pro Thermor 2019